ESP32-P4NRW32 (rev 1.x), a C6 on SDIO and the high-speed USB on its own connector. But the camera socket is 24-pin for its own camera, at 2.8 and 1.8 V with I2C at 1.8 V, so a Raspberry Pi ribbon does not fit.
What ESP-KVM needs from a board
- ✓ 32 MB of PSRAM. It has the 32 MB of PSRAM the video needs.
- ✗ A camera connector the capture board fits. The HDMI capture board's camera ribbon does not fit, or there is no free camera connector. Connector: 24-pin, Elecrow's own.
- ✓ High-speed USB towards the target. Its high-speed USB comes out where it can face the target as a device.
- ✓ A network. It has a network: Ethernet, or Wi-Fi through a co-processor.
Chip revision: 1.x.
Read from the maker’s documents, checked 2026-11, not from a board in hand.
ESP-KVM is free, open-source firmware that turns an ESP32-P4 board into an IP-KVM: another computer’s screen, keyboard and mouse in your browser, from the BIOS up. The boards it runs on →