Built on the JC-ESP32P4-M3 module, the same as the supported Guition ESP32-P4-M3-Dev, with IP101 Ethernet, a C6 and a high-speed USB-C. But its camera socket is 15-pin at 0.3 mm pitch, so a Raspberry Pi ribbon does not fit without an adapter.
What ESP-KVM needs from a board
- ✓ 32 MB of PSRAM. It has the 32 MB of PSRAM the video needs.
- ✗ A camera connector the capture board fits. The HDMI capture board's camera ribbon does not fit, or there is no free camera connector. Connector: 15-pin 0.3 mm.
- ✓ High-speed USB towards the target. Its high-speed USB comes out where it can face the target as a device.
- ✓ A network. It has a network: Ethernet, or Wi-Fi through a co-processor.
The chip revision is not known.
ESP-KVM is free, open-source firmware that turns an ESP32-P4 board into an IP-KVM: another computer’s screen, keyboard and mouse in your browser, from the BIOS up. The boards it runs on →