Everything the KVM needs on a small board, but no wired port: Wi-Fi is the only link. The AI Kit (DFR1237) is the same board with accessories in the box.
Wiring
- The USB-C beside the RST button is power, flashing and the log.
- The other USB-C is the OTG-HS that goes to the target.
- Its 5 V ties to the board's rail, so unplugging it at the target's end restarts the KVM.
Confirmed by a user
@Diego-fe ran it in #63: capture, USB and Wi-Fi work. At first Wi-Fi stalled under a 1080p stream, and two fixes came out of that:
- 0.56.1: the board has no pull-ups on the SDIO lines to the C6, so the firmware turns on the chip's own.
- 0.56.2: over Wi-Fi the P4 ran out of internal RAM under load.
On 0.56.2 the picture runs without a break, at about 9 fps of 1080p MJPEG.
