← All boards

Compare capture boards

The HDMI capture boards ESP-KVM reads, side by side: the bridge chip, the connector, whether a monitor can stay on the target, and which ESP32-P4 boards each one fits. Pick the ones you are choosing between. "Untested" means nobody has run ESP-KVM with it yet.

Compare the ESP32-P4 boards →

45 x 30 mmGeekworm C790
56 x 56 mmGeekworm C792
StatusTestedUntestedTestedTested
BridgeToshiba TC358743Toshiba TC358743, behind a GSV2001 splitterToshiba TC358743Lontium LT6911D
InputHDMIHDMI, up to 4K60; 4K is scaled down to 1080p at the same refresh ratefull-size HDMIHDMI
HDMI outnopass-through (VIDEO-OUT), the same picture as the inputnono
15-pin ribbonyes, on the front (1.0 mm, the Pi 4 kind); cable in the boxyes, on the front (1.0 mm, the Pi 4 kind); cable in the boxyes (1.0 mm, the Pi 4 kind); it also powers the boardno
22-pin ribbonyes, on the back (0.5 mm, the Pi 5 kind); cable in the boxyes, on the back (0.5 mm, the Pi 5 kind); cable in the boxno; the P4-ETH needs a 15-to-22-pin ribbonno
24-pin ribbon (M5Stack)nononoyes, M5Stack's own flat cable to the Unit PoE-P4
Works with13 ESP32-P4 boards13 ESP32-P4 boards13 ESP32-P4 boardsonly M5Stack: Unit PoE-P4, Unit PoE-P4X
HDMI-CECyes, tried with a Steam Deck, a Nintendo Switch and an Android TV box-same chip as the C790; not tried on this boardno; the line is wired to the chip, but its CEC is undocumented
HDMI audioI2S on its own 5-pin connector; not captured yetI2S on its own connector; not captured yet-no; the chip's audio pins are not connected
Power-its own 5 V input, cable in the box--
Measured1080p H.264 at 22-24 fps on the Function EV, 1080p MJPEG at 20 fps on the P4-ETH; my own figures on this site are all with this board-1080p H.264 at 23 fps on the WIFI6-POE-ETH720p MJPEG at 23 fps
microSD---yes